How To Clean The Scale Inside The Solar Water Heater?

1. Drain the water from the water tank, hold the vacuum tube with both hands, and rotate it back and forth to loosen it.
2. Then push the water tank up and push it to the bottom to come out of the base, and then pull it down to take out the vacuum tube and pour out the water in the vacuum tube.
3. Rinse repeatedly with clean water. After cleaning all the vacuum tubes in sequence, add tap water to the water tank to allow the scale in the water tank to flow out. You can purchase special cleaning fluid for solar water heaters. Its main ingredients include food acids, synergists, metal protective agents, etc. Generally, it can be soaked for about 10 minutes, and the effect is better in warm water.
4. Then install the vacuum tubes one by one. The installation condition of the water tank should be checked during installation. Check whether the sealing ring at the hole is intact. If it is damaged, replace it with a new one.
5. In addition, during use, try to add water to the water tank to reduce the water temperature in the water tank. It is best not to exceed 75 degrees to reduce the generation of scale.